Now, since that thread has the basics you will need. You need to get the number off the chip on your highpoint controller card. Then enable one of these in your ide section of your kernel.
< > HPT34X chipset support
< > HPT36X/37X chipset support
Wichever one you need put a * in it and not a M if you want to boot from it.
]]>Why won't it find scsi.h, and how can I figure out where it's looking if it's looking in the wrong place? Most of what's in the makefile is beyond me.
OR, don't I need to do any of this because the cards will run under Arch just fine as it is set up?
]]>