ACPI: resource it87 [io 0x0295-0x0296] conflicts with ACPI region IP__ [??? 0x00000295-0x00000296 flags 0x5f]
ACPI: If an ACPI driver is available for this device, you should use it instead of the native driver
zd1211rw 2-1:1.0: error ioread32(CR_REG1): -110
eth0: link down
usb 2-1: USB control request for firmware upload failed. Error number -110
usb 2-1: Could not upload firmware code uph. Error number -110
zd1211rw 2-1:1.0: couldn't load firmware. Error number -110
usb 2-1: USB control request for firmware upload failed. Error number -110
usb 2-1: Could not upload firmware code uph. Error number -110
zd1211rw 2-1:1.0: couldn't load firmware. Error number -110
usb 2-1: USB control request for firmware upload failed. Error number -110
usb 2-1: Could not upload firmware code uph. Error number -110
zd1211rw 2-1:1.0: couldn't load firmware. Error number -110
usb 2-1: USB control request for firmware upload failed. Error number -110
usb 2-1: Could not upload firmware code uph. Error number -110
zd1211rw 2-1:1.0: couldn't load firmware. Error number -110
dmesg (showing the error)
cfg80211: Calling CRDA to update world regulatory domain
zd1211rw 1-4:1.0: error ioread32(CR_REG1): -71
Once I unplug and replug the adaptor and hit refresh in wicd, it can connect again.
Now, this happens randomly, sometimes it will be fine, on the occasions that the adaptor connects successfully upon bootup, dmesg shows:
wlan0: authenticated
wlan0: associated
and in my DAEMONS in rc.conf, wicd is the only wireless connection program, no scripts or anything else.
So my question to you, what would cause this to happen?
]]>