Anyway, solved.
]]>I commute to campus, so I can't check the output of dmesg until Tuesday.
I'll install and configure wicd ahead of time to see if it works.
]]>ctrl_interface=DIR=/run/wpa_supplicant GROUP=wheel
update_config=1
dot11RSNAConfigSATimeout=120
device_name=Alienware
device_type=1-0050F204-1
country=US
ap_scan=1
network={
ssid="WIRELESS-PITTNET"
proto=RSN
key_mgmt=WPA-EAP WPA-EAP-SHA256
pairwise=CCMP
auth_alg=OPEN
group=CCMP
eap=PEAP
identity="*****"
password="*****"
phase1="peaplabel=1"
phase2="auth=MSCHAPV2"
}
I've tried changing various settings, since the rather unhelpful instructions given by the university simply state that the network is WPA2 using AES encryption and PEAP. My wpa_supplicant output with -dd is this:
wpa_supplicant v2.0
Successfully initialized wpa_supplicant
Initializing interface 'wlan0' conf '/etc/wpa_supplicant' driver 'wext' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant' -> '/etc/wpa_supplicant'
Reading configuration file '/etc/wpa_supplicant'
WEXT: cfg80211-based driver detected
wext: interface wlan0 phy: phy0
rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0
SIOCGIWRANGE: WE(compiled)=22 WE(source)=21 enc_capa=0xf
capabilities: key_mgmt 0xf enc 0x1f flags 0x0
netlink: Operstate: linkmode=1, operstate=5
wlan0: Own MAC address: c4:46:19:56:ac:a3
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wlan0: RSN: flushing PMKID list in the driver
wlan0: State: DISCONNECTED -> INACTIVE
WPS: Set UUID for interface wlan0
WPS: UUID based on MAC address - hexdump(len=16): 27 ad 2c dd 6b 1b 5c 4c b5 33 b5 57 fb c9 c7 4f
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: Supplicant port status: Unauthorized
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: Supplicant port status: Unauthorized
EAPOL: Supplicant port status: Unauthorized
wlan0: Added interface wlan0
wlan0: State: INACTIVE -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
netlink: Operstate: linkmode=-1, operstate=5
Daemonize..
Any ideas what might be wrong?
]]>