<b>/etc/rc.conf</b>
MODULES=(!usbserial !ide-scsi dmfe dummy)
<b>/etc/inittab</b>
id:3:initdefault: (change level 3 to 5 --> id:5:initdefault:)
Tag xdm line (or remove) and make a new line for kdm:
# x:5:respawn:/usr/X11R6/bin/xdm -nodaemon
x:5:respawn:/opt/kde/bin/kdm -nodaemon
pacman dmfe
insmod dmfe
insmod dummy
then start kdm and appear my eth0 davicom
]]>i'm now are enjoy kde!
my integrated Davicom 9102, cause i driber, but don't works
and the refresh that appera in hwd is bad, cause my monitor appear with "crazy lines" in my monitor
Best is to browse on internet. I took a brief look (yahoo search) about Davicom 9100 ethernet what seems to be mostly supported by Windows.... but there was a comment Davicom also includes drivers for Linux. Check if included on your Davicom driver CD.
Try if Tulip works for Davicom:
modprobe tulip
Check the specification label at the back of your monitor... or manual ... or internet or try to change the H and V rate with xf86cfg:
Example:
HorizSync: 31.5 - 48.5; Non-Interlaced SVGA, 1024x768 @ 60 Hz, 800x600 @ 72 Hz
VertRefresh: 50 - 70
now, i wanted del wintendo, but now have last 2 problem
my integrated Davicom 9102, cause i driber, but don't works
and the refresh that appera in hwd is bad, cause my monitor appear with "crazy lines" in my monitor,
now, i can work, but "beats" the screen
sorry tooo questions, but i want really learn about it
]]>Save the file in /etc/X11/ as "XF86Config-4" not as "XF86Config"
This really shouldn't matter. On my systems I save it as XF86Config with no problems.
]]>thank, and now i try that
]]>Run in root:
xf86cfg -textmode
Save the file in /etc/X11/ as "XF86Config-4" not as "XF86Config"
PS
My vga card (onboard vga chip) is SIS 630 and works fine.... in general all SIS cards are suppose to work well with Linux.
yeah, i do that, but that dont't resolv the problem
****************
*Xconsole | *
* |-------*----> that's the line appear, and my pc "freeze"
* | *
* | *
****************
Option "swcursor"
This sometimes helps with SiS cards
Scott
]]>i see my configuration with hwd and no good result abaut it
what would be??
Hwd doesn't automatically configure the hardwares... you have to do it manually.
Depending what desktop you have installed.... I assume KDE, try this:
<b>1.</b> Run Hwd in root:
hwd
<b>2.</b> Copy XF86Config-4.hwd:
cd /etc/X11
cp -f XF86Config-4.hwd XF86Config-4
<b>3.</b> Start KDM (if KDE is installed):
kdm
i see my configuration with hwd and no good result abaut it
what would be??
spanish
hola, tengo una sis 620, ye no puedo ejecutar startx, pues cuando pongo enla consola esto, aparece la xconsola pero aparece con una raya en la mitad de la pantalla y se me keda pegado el pc.
probe con varias resoluciones y ninguna novedad, revise mi hardware con el hwd y nada nuevo..
que puede ser?