[ 33.074482] usb 3-10.2.2: USB disconnect, device number 6
[ 34.413953] usb 3-10.2.2: new low-speed USB device number 8 using xhci_hcd
[ 34.432298] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[ 34.434796] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input20
[ 34.434983] hid-generic 0003:046D:C05A.0005: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[ 61.147553] usb 3-10.2.2: USB disconnect, device number 8
[ 62.615176] usb 3-10.2.2: new low-speed USB device number 9 using xhci_hcd
[ 62.633547] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[ 62.636033] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input21
[ 62.636217] hid-generic 0003:046D:C05A.0006: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[ 74.145665] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X
[ 74.248735] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X
[ 74.248808] IPv6: ADDRCONF(NETDEV_UP): eno1: link is not ready
[ 74.957696] IPv6: ADDRCONF(NETDEV_UP): enp3s0: link is not ready
[ 77.334059] igb: enp3s0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
[ 77.334431] IPv6: ADDRCONF(NETDEV_CHANGE): enp3s0: link becomes ready
[ 89.220517] usb 3-10.2.2: USB disconnect, device number 9
[ 90.689570] usb 3-10.2.2: new low-speed USB device number 10 using xhci_hcd
[ 90.707740] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[ 90.710117] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input22
[ 90.710332] hid-generic 0003:046D:C05A.0007: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[ 96.278579] nvidia 0000:01:00.0: irq 51 for MSI/MSI-X
[ 97.071684] NVRM: Your system is not currently configured to drive a VGA console
[ 97.071686] NVRM: on the primary VGA device. The NVIDIA Linux graphics driver
[ 97.071687] NVRM: requires the use of a text-mode VGA console. Use of other console
[ 97.071688] NVRM: drivers including, but not limited to, vesafb, may result in
[ 97.071688] NVRM: corruption and stability problems, and is not supported.
[ 143.700304] usb 3-10.2.2: USB disconnect, device number 10
[ 144.398155] usb 3-10.2.2: new low-speed USB device number 11 using xhci_hcd
[ 144.416346] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[ 144.418572] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input23
[ 144.418719] hid-generic 0003:046D:C05A.0008: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[ 250.352306] usb 3-10.2.2: USB disconnect, device number 11
[ 251.307626] usb 3-10.2.2: new low-speed USB device number 12 using xhci_hcd
[ 251.325946] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[ 251.328288] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input24
[ 251.328530] hid-generic 0003:046D:C05A.0009: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[adomas@localhost ~]$
Any ideas how to fix this so I don't need to reconnect the mouse? I think it might be something with USB 3 support...
]]>