"lspci | grep net" says the following:
"Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller"
mh,...atm i cant test this, but would the command be "modprobe natsemi"?
and where to enter this?! :>>
edit: i edited the rc.conf at installation and did type eth0=dhcp thingy in there. always did so with 0.7 base installation cd, :>>
regards,
detto
Check if you have used
eth0="dhcp"
NOTE THE DOUBLE QUOTES
]]>No other helping hand here atm? :oops:
I booted from NoodleCD again, typed "modprobe natsemi" (yep, that's my networkcard-module), then "/arch/setup/" chose FTP Installation and wanted to configure DHCP but it just gives me the same nothing-saying-error!! :shock: :evil: :evil:
What tha?.......
has anybody a clue how to get around this annoying problem?!
THX!
regards,
detto
"Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller"
mh,...atm i cant test this, but would the command be "modprobe natsemi"?
and where to enter this?! :>>
edit: i edited the rc.conf at installation and did type eth0=dhcp thingy in there. always did so with 0.7 base installation cd, :>>
regards,
detto
I tried to install Arch with latest CD 0.7.1. I choose FTP Install, and wait for the DHCP Setup to complete, but it alway fails with a message like "DHCPCD could'nt start..." , so i tried installing from CD, everything went fine, rebooted, but as i guesses ii had no internet connection (or lan, im connected to a router,btw).
So my question to you is, what i have to do to make this work here?
Dont wanna miss Arch! :>>