tpowa wrote:is the module not loaded? because else it could be a timing issue
I didn't check. I installed old one which works everything .
Thanks for your help and I am sorry that I took your time...
Again me...udev 0.84 works now. I don't know why but I did try again, reboot twice and works. Maybe was a problem because Rosegarden freezing the computer and shutdown was not correct.
Thank you again for help
]]>is the module not loaded? because else it could be a timing issue
I didn't check. I installed old one which works everything .
Thanks for your help and I am sorry that I took your time...
do you also use complete testing?
yes
]]>what udev are you using?
The last one, I think that is 0.84...
]]>8139cp or 8193too card?
that are the only ones with the same number in kernel.
you have to load these by hand
In KDE KInfoCenter I have about my card which is on board:
02:05.0 Ethernet controller: 3Com Corporation 3c940 10/100/1000Base-T [Marvell] (rev 12)
First time when I commented hwd and use MOD_AUTOLOAD was okay. Than I turned comp. off because freezing when I tried to run rosegarden and after that I have a problem. I use hwd again and is okay just I cannot use memory stick reader, ahhhhhhhhh.
]]>udevinfo -a -p /sys/devices/pci0000:00/0000:00:10.4/usb1/1-1
which is what i needed cause my usb device creates a character device not a block
my version of udev is same as yours i upgraded to testing to see if it would fix my problem it didnt so i had fun learning bout writing udev rules
don't use hwd, it's not perfect as you see just enable MOD_AUTOLOAD="yes", udev does the rest
If I have MOD_AUTOLOAD="yes" and I don't load hwd I don't have network
lo="lo 127.0.0.1"
eth0="dhcp"
INTERFACES=(lo eth0)
To use hwd: Just install the lshwd package and replace hotplug with hwd in your DAEMONS array.
To use hwdetect: Look for a line in /etc/rc.conf that starts with MOD_AUTOLOAD and set it to "yes". If you don't have the line, add it:
MOD_AUTOLOAD="yes"
I replaced hotplug with hwd in my DAEMONS array.
I am using hwd (not hwdetect MODAUTOLOAD="yes").