Potentially there's a module you need to load in order to get things working... that's the only thing I can suggest I'm afraid :?
]]>I have an e130 sansa player by san-disk. the player has an expension slot for an sd card. Now, on windows I see 2 new hard drives, one for built-in memory, and one for the sd card.
but on arch, I can only mount the built-in memory. what brings me hope is the dmesg log:
usb 1-1: new full speed USB device using uhci_hcd and address 3
usb 1-1: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
Vendor: SanDisk Model: Sansa e130 Rev: 0100
Type: Direct-Access ANSI SCSI revision: 04
usb-storage: device scan complete
Driver 'sd' needs updating - please use bus_type methods
SCSI device sda: 1012480 512-byte hdwr sectors (518 MB)
sda: Write Protect is off
sda: Mode Sense: 38 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 1012480 512-byte hdwr sectors (518 MB)
sda: Write Protect is off
sda: Mode Sense: 38 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
UDF-fs: No VRS found
UDF-fs: No VRS found
as you can see, I think it can also find the second memory.
my question: Is there a way I can mount my sd memory? (mabye there is something I don't know about the 'mount' command?) I would like to be able to mount both of them at the same time, but even one at a time is also OK.