Moving to NC...
]]>
[ 3510.666354] ready
[ 3510.666840] sd 6:0:0:0: [sdb] 1953458176 512-byte logical blocks: (1.00 TB/931 GiB)
[ 3510.667823] sd 6:0:0:0: [sdb] Write Protect is off
[ 3510.667828] sd 6:0:0:0: [sdb] Mode Sense: 47 00 10 08
[ 3510.668822] sd 6:0:0:0: [sdb] No Caching mode page found
[ 3510.668832] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3510.777388] sdb: sdb1 sdb2
[ 3510.780811] sd 6:0:0:0: [sdb] Attached SCSI disk
[ 3724.376054] usb 2-1.3: USB disconnect, device number 11
[ 3724.609283] usb 2-1.3: new high-speed USB device number 12 using ehci-pci
[ 3724.787588] usb-storage 2-1.3:1.0: USB Mass Storage device detected
[ 3724.788726] scsi host6: usb-storage 2-1.3:1.0
[ 3725.813589] scsi 6:0:0:0: Direct-Access WD Elements 25A2 1004 PQ: 0 ANSI: 6
[ 3725.814892] sd 6:0:0:0: [sdb] 1953458176 512-byte logical blocks: (1.00 TB/931 GiB)
[ 3725.815882] sd 6:0:0:0: [sdb] Write Protect is off
[ 3725.815887] sd 6:0:0:0: [sdb] Mode Sense: 47 00 10 08
[ 3725.819530] sd 6:0:0:0: [sdb] No Caching mode page found
[ 3725.819541] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3726.270577] sdb: sdb1 sdb2
[ 3726.275510] sd 6:0:0:0: [sdb] Attached SCSI disk
I have installed ntfs-3G but still don't see the disk showing up. Any ideas please?
]]>