"Mount the EFI system partition and in the remainder of this section, substitute esp with its mount point."
]]>"grub-install --target=x86_64-efi --efi-directory=/boot/efi --bootloader-id=GRUB"
and
"grub-mkconfig -o /boot/grub/grub.cfg"
, but it's not creating any new entries in NVRAM. I've also tried creating new entries with efibootmgr. The exact command I used was
efibootmgr --create --disk /dev/sdb --part 1 --loader /boot/efi/--label "Arch Linux" --unicode
. That did not work either. When I selected the entry within uefi, it just blinked once and returned me the uefi screen. I tried using bcfg next and ran the following command
bcfg boot add 1 fs0:\vmlinuz-linux "Arch Linux"
successfully. . I was unable to run the second entry listed in the wiki
bcfg boot -opt 1 "root=/dev/sdb1 initrd=\initramfs-linux.img"
, I got an error of invalid argument. I looked in my uefi entries and found an entry in UEFI, but whenever I run it I my computer goes into kernel panic mode.
]]>