It's just a GNU Parted FAQ
Does GNU Parted support ext2/ext3 extended attributes?
No, not yet.
And in addition, look at this!
Does GNU Parted support Intel EFI/GPT partition tables?
Yes.
Now we know, who is in fault
]]>2) There is nothing weird in the partition numbering, it's normally. I got the same with different partitioning tools. Yor extended partition is actually primary partition #2. So you can create primary #3 and primary #4, but only one of primary (any!) can be extended.
You're right.
I use an extended partition only when i need more than 3 partitions, so for me it is uncommon to have an extended partition that's not number 4.
I forgot that this is no fixed rule, just a personal preference.
2) There is nothing weird in the partition numbering, it's normally. I got the same with different partitioning tools. Yor extended partition is actually primary partition #2. So you can create primary #3 and primary #4, but only one of primary (any!) can be extended.
]]>Code:
Disk /dev/hda: 80.1GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Number Start End Size Type File system Flags
1 32.3kB 10.7GB 10.7GB primary ext3 boot
2 38.9GB 80.1GB 41.1GB extended
6 38.9GB 40.0GB 1077MB logical linux-swap
5 40.0GB 80.1GB 40.0GB logical ext3
There's something weird in the partition numbering shown by gnu parted.
Normally partition 4 is the extended partition, not 2 .
I think the problem started when those partitions were made !
]]>ext3 = ext2 + journaling, but it's not so simple. The choice depend on
- your worry about performance of system
- your worry about reliability of your data
- hardware abilities of your machine
If you want, i'll try to explain
]]>I have this disk configuration
GNU Parted 1.7.1 (from Debian)
Disk /dev/hda: 80.1GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Number Start End Size Type File system Flags
1 32.3kB 10.7GB 10.7GB primary ext3 boot
2 38.9GB 80.1GB 41.1GB extended
6 38.9GB 40.0GB 1077MB logical linux-swap
5 40.0GB 80.1GB 40.0GB logical ext3
I can't edit partitions with Arch Setup! cfdisk (2.12r) reports FATAL ERROR: Bad logical partition 6: enlarged logical partition overlap
So i try parted (1.8.8). "check 1" and "check 5" commands reports Error: File system has an incompatible feature enabled
I found information, that parted (exactly libparted) has no support for some ext2 (or ext3, i don't know) features: dir_index and resize_inode.
Also i found information that cfdisk can plainly report a fatal error, where is no error at all (see bugreport).
Which features enabled on my /dev/sda1.
# tune2fs -l /dev/sda1
...
Filesystem features: has_journal resize_inode dir_index filetype needs_recovery sparse_super
...
Well, i can disable dir_index.
# tune2fs -O ^dir_index /dev/sda1
But i can't disable resize_inode!
tune2fs -O ^resize_inode /dev/sda1
Invalid filesystem option set: ^resize_inode
...and parted still reports "incompatible feature enabled"
I exactly know, that trouble in utils and not with my disk or file system! So, does anybody know, how to use parted in this case or what to do with cfdisk?
]]>