dmesg:
hub 5-0:1.0: unable to enumerate USB device on port 7
usb 4-1: new full speed USB device using uhci_hcd and address 27
usb 4-1: device descriptor read/64, error -71
usb 4-1: device not accepting address 27, error -71
usb 4-1: new full speed USB device using uhci_hcd and address 28
usb 4-1: device descriptor read/64, error -71
usb 4-1: device descriptor read/all, error -71
usb 4-1: new full speed USB device using uhci_hcd and address 29
usb 4-1: device descriptor read/8, error -71
usb 4-1: device descriptor read/8, error -71
usb 4-1: new full speed USB device using uhci_hcd and address 30
usb 4-1: device descriptor read/8, error -71
usb 4-1: device descriptor read/8, error -71
hub 4-0:1.0: unable to enumerate USB device on port 1
/var/log/messages.log
Jun 8 15:25:09 P usb 4-1: new full speed USB device using uhci_hcd and address 32
Jun 8 15:25:09 P usb 4-1: new full speed USB device using uhci_hcd and address 33
Jun 8 15:25:09 P usb 4-1: new full speed USB device using uhci_hcd and address 34
Jun 8 15:25:10 P usb 4-1: new full speed USB device using uhci_hcd and address 35
lsusb
Bus 004 Device 001: ID 1d6b:0001
Bus 005 Device 002: ID 413c:a005 Dell Computer Corp.
Bus 005 Device 001: ID 1d6b:0002
Bus 003 Device 001: ID 1d6b:0001
Bus 002 Device 027: ID 046d:c012 Logitech, Inc. Optical Mouse
Bus 002 Device 001: ID 1d6b:0001
Bus 001 Device 001: ID 1d6b:0001
I have loaded all kernel modules which are, according to the wiki cups tutorial, neccessary: usblp, lp, parport_lp.
During my research, I even got a response from usblp:
usblp0: USB Bidirectional printer dev 26 if 0 alt 0 proto 2 vid 0x1A86 pid 0x7584
usblp0: nonzero read bulk status received: -84
usblp0: nonzero read bulk status received: -84
usb 4-1: USB disconnect, address 26
But I'm not sure, how I got so far
Is there someone who also uses an adapter for printing and is able to help me?
]]>