You are not logged in.

#1 2010-09-17 05:58:39

LRRR
Member
From: Germany
Registered: 2010-08-29
Posts: 26

(SOLVED) rc.conf bluetooth at start

Hi,

try to recognize my bluetooth dongle from startup. When I'm in arch plug him out and back in brings him to life. In /etc/rc.conf i put "bluetooth" in the deamons section at last.

DAEMONS=(syslog-ng netfs crond dbus hal slim wicd alsa bluetooth)

but at startup i only see

slim
wicd

i use blueman-applet for bluetooth, but i think that arch should detect him at startup.

Last edited by LRRR (2010-09-17 14:08:24)


...Emperor of the planet Omicron Persei 8.

Offline

#2 2010-09-17 06:29:42

ngoonee
Forum Fellow
From: Between Thailand and Singapore
Registered: 2009-03-17
Posts: 7,354

Re: (SOLVED) rc.conf bluetooth at start

You should put slim behind everything, I believe.


Allan-Volunteer on the (topic being discussed) mailn lists. You never get the people who matters attention on the forums.
jasonwryan-Installing Arch is a measure of your literacy. Maintaining Arch is a measure of your diligence. Contributing to Arch is a measure of your competence.
Griemak-Bleeding edge, not bleeding flat. Edge denotes falls will occur from time to time. Bring your own parachute.

Offline

#3 2010-09-17 14:07:53

LRRR
Member
From: Germany
Registered: 2010-08-29
Posts: 26

Re: (SOLVED) rc.conf bluetooth at start

thank you now it works !!!

DAEMONS=(syslog-ng netfs crond dbus hal wicd alsa bluetooth slim)

now my usb bluetoth dongle is found wink and a blueman-applet & in my openbox autostart.sh does the rest.


...Emperor of the planet Omicron Persei 8.

Offline

Board footer

Powered by FluxBB