You are not logged in.

#1 2010-04-06 04:07:44

crazywizzard
Member
Registered: 2010-04-06
Posts: 1

[solved] wired but no wireless ( intel 5300 )

[ Solution found, see last line ]

ifconfig -a lists a wlan0 device, ifconfig (without -a) does not

lspci shows "09:00.0 Network controller: Intel Corporation PRO/Wireless 5300 AGN [Shiloh] Netwrok Connection"

iwlagn and iwlcore are in my modules list and not blacklisted

Networkmanager works perfectly for the wired connection, however the option to "enable wireless" is greyed out.  I have installed the firmware ( iwlwifi-5000-ucode ).

What is my next step to get wireless working?

EDIT: more info: "rfkill list" shows the device as hard blocked.  I checked that wireless was enabled in the bios and I tried pressing the kill switch again ( Fn + F8 ) but no change.
I also tried "rfkill unblock 0" and "rfkill unblock all"

EDIT AGAIN: I replaced the wireless card a while back ( used to be a realtek card ).  I pressed the wireless kill button when trying to figure out how to get a usb adapter to work for another computer.  Now the wireless wont turn back on.  Are there any known ways to fix this problem ( other than what I found about taping over a pin on the card ).  This seems to be my problem, The laptop dual-boots windows and I cannot get it to work there either.

Solution: Remove battery and power cord...  the simplest solution of all.

Last edited by crazywizzard (2010-04-06 06:06:52)

Offline

Board footer

Powered by FluxBB