You are not logged in.
I have a fresh install and if I run "sudo dhcpcd eth0" then it works fine, but it doesn't start by itself.
I tried
sudo systemctl enable dhcpcd
but the response was
Failed to issue method call: No such file or directory
I knew how to do this when we had rc.conf.
How do I do it now?
Last edited by CaptainKirk (2012-11-15 19:48:44)
Offline
systemctl enable dhcpcd@eth0.service
Straight from the network part of the beginners guide...
Offline
Ah, righto. I was looking at the page but I was stuck on the "Establish an internet connection" section, which actually says dhcpcd is started automatically--I guess that means just for the live CD. I didn't find the "Configure the network" section.
Thank you.
Offline