yakuake not renaming tabs automatically

Cinder · 2009-07-20 10:30:55

Hello,

I've been trying to figure this out for a few days now but I don't get anything. I've recently re-installed my laptop since the hard drive blew up and on the new installation yakuake does not automatically rename tabs according to working dir/command/hostname.

My tab title format is set to %d : %n and remote tab title format is set to %h (which should rename the tab to the hostname you're sshing to for example). Now I've noticed this won't work if for example your ssh command is an alias for ssh with some additional parameters, however this is not the case here.

Colleague of mine had this problem an year back which was (according to him) caused by perl, however I can't find anything wrong on my side.

Any suggestions?

Cinder · 2009-07-21 06:39:39

bump

djszapi · 2009-07-25 18:56:05

I don't know the answer, but if i see well it's not a very well documented matters, so if it will work for you, you can make from it a wikipage

Arch Linux

#1 2009-07-20 10:30:55

yakuake not renaming tabs automatically

#2 2009-07-21 06:39:39

Re: yakuake not renaming tabs automatically

#3 2009-07-25 18:56:05

Re: yakuake not renaming tabs automatically

Board footer