Arch Linux

hadi

Member

From: Iran

Registered: 2010-10-01

Posts: 16

Connecting to Broadband Router

I can connect to internet via router but I cant see my router configuration page with entering 192.168.1.1 in chromium address bar , does anyone know what
the problem is ?

And i tried nmap 192.168.1.1 and it says port 80 is filtered :

nmap 192.168.1.1

Starting Nmap 5.21 ( http://nmap.org ) at 2010-10-09 13:53 IRST
Nmap scan report for mygateway1.ar7 (192.168.1.1)
Host is up (0.35s latency).
Not shown: 982 closed ports
PORT      STATE    SERVICE
21/tcp    open     ftp
22/tcp    filtered ssh
23/tcp    filtered telnet
24/tcp    filtered priv-mail
25/tcp    filtered smtp
26/tcp    filtered rsftp
30/tcp    filtered unknown
32/tcp    filtered unknown
33/tcp    filtered dsp
37/tcp    filtered time
42/tcp    filtered nameserver
43/tcp    filtered whois
49/tcp    filtered tacacs
53/tcp    filtered domain
70/tcp    filtered gopher
79/tcp    filtered finger
80/tcp    filtered http
52869/tcp open     unknown
MAC Address: 00:1C:F0:3B:45:77 (D-Link)

Nmap done: 1 IP address (1 host up) scanned in 85.03 seconds

scar

Member

From: Hungary

Registered: 2009-10-01

Posts: 442

Re: Connecting to Broadband Router

try to install the "inetutils" package, and then:

# telnet 192.168.1.1 80

if you have an error message, you cannot connect to your router
if you have someting like a blank screen, you are connected - try another browser

---

“The future has already arrived. It's just not evenly distributed yet.”
― William Gibson

new2arch

Member

Registered: 2008-02-25

Posts: 235

Re: Connecting to Broadband Router

Try disabling Iptables (if you run it). I had similar issues with not being able to connect to my router unless iptables was disabled. (Probably some misconfigurations in iptables)