You are not logged in.

#1 2008-03-23 22:32:58

hendricks
Member
From: east of the ol' miss
Registered: 2008-03-22
Posts: 4

xorg and video drivers

Question:  I have an A20m thinkpad on which i am bulding arch.  auto detection has determined my video board is a Rage Mobility P/M AGP 2x, and it wants to use "mach64" as the driver, which I do not have.  Can i use the open ati driver?  Mach64 is still under development, right?
When I run the xorg server test I get FATAL error "mach64" even if I have changed the driver to "ati" and installed it.  Any suggestions would be great!

Thank you!

Offline

#2 2008-03-23 22:34:47

tehanomaly
Member
From: UK
Registered: 2007-11-28
Posts: 12

Re: xorg and video drivers

Can you post your /etc/X11/xorg.conf file? - it may help give a solution wink


'I cannot teach anybody anything, I can only make them think...'

Offline

#3 2008-03-23 22:46:06

hendricks
Member
From: east of the ol' miss
Registered: 2008-03-22
Posts: 4

Re: xorg and video drivers

my system is new, and i don't have a GUI up yet, but I can type out the bits that you think might give insight.  Which would you like?

Offline

#4 2008-03-23 23:01:16

tehanomaly
Member
From: UK
Registered: 2007-11-28
Posts: 12

Re: xorg and video drivers

How are you running the xorg server test?  The best bits would be the "Module" and "Device" sections from the .conf file that is being used in the server test (usually xorg.conf)

Another thing is to check that you have the xf86-video-ati and libgl packages.

Check out http://wiki.archlinux.org/index.php/ATI too - pretty much everything related to ATI & X big_smile


'I cannot teach anybody anything, I can only make them think...'

Offline

#5 2008-03-23 23:29:45

hendricks
Member
From: east of the ol' miss
Registered: 2008-03-22
Posts: 4

Re: xorg and video drivers

I am running the test on a xorg.conf.new file. Results are:

FATAL: Module mach64 not foud
(EE) [drm] drmOpen failed
(EE) MACH64(0): [dri] DRIScreenInit Failed

Device Section of xorg.conf

Identifier  "Card0"
Driver      "ati"
VendorName "ATI Tech Inc"
BoardName  "Rage Mobility P/M AGP 2x"
BusID          "PCI:1:0:0"

I will read that document.  Any thoughts on the above?

Offline

#6 2008-03-24 16:24:25

tehanomaly
Member
From: UK
Registered: 2007-11-28
Posts: 12

Re: xorg and video drivers

These threads: http://bbs.archlinux.org/viewtopic.php?pid=324509 -> http://bbs.archlinux.org/viewtopic.php?id=43041 may help - I wasn't aware that the mach64 module had been removed from xf86-video-ati roll

Try rebuilding xf86-video-ati using info from the above threads and see if that helps.  Your xorg.conf(.new) looks ok so with the new module you (hopefully) should be ok cool

Fingers crossed!


'I cannot teach anybody anything, I can only make them think...'

Offline

Board footer

Powered by FluxBB