You are not logged in.
Hi i have bought one TP-LINK WN321G.
[ubermensch@tux-devil ~]$ sudo lsusb -v -d 148f:2573
Bus 002 Device 003: ID 148f:2573 Ralink Technology, Corp.
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x148f Ralink Technology, Corp.
idProduct 0x2573
bcdDevice 0.01
iManufacturer 1 Ralink
iProduct 2 54M.USB.......
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0x80
(Bus Powered)
MaxPower 300mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 255 Vendor Specific Subclass
bInterfaceProtocol 255 Vendor Specific Protocol
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Device Qualifier (for other device speed):
bLength 10
bDescriptorType 6
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
bNumConfigurations 1
Device Status: 0x0000
(Bus Powered)
[ubermensch@tux-devil ~]$
I looked for a firmware that supported injection and monitor mode. I thought about having found what serves me in AUR : http://aur.archlinux.org/packages.php?ID=15377but after I have installed the package the peripheral one has kept on not working.
Sets some outputs that I can be useful:
[ubermensch@tux-devil ~]$ sudo lsmod | grep rt
Password:
rt73 220800 0
rt2500usb 22272 0
parport_pc 34884 1
rt73usb 24832 0
rt2x00usb 9600 2 rt2500usb,rt73usb
rt2x00lib 20480 3 rt2500usb,rt73usb,rt2x00usb
parport 31596 3 parport_pc,ppdev,lp
rfkill 6036 1 rt2x00lib
input_polldev 3720 1 rt2x00lib
crc_itu_t 2304 1 rt2x00lib
mac80211 130572 2 rt2x00usb,rt2x00lib
agpgart 28244 2 nvidia,intel_agp
rtc_cmos 9120 0
rtc_core 15516 1 rtc_cmos
rtc_lib 2944 1 rtc_core
usbcore 129904 10 rt73,rt2500usb,rt73usb,rt2x00usb,usbhid,snd_usb_audio,snd_usb_lib,ehci_hcd,uhci_hcd
[ubermensch@tux-devil ~]$
[ubermensch@tux-devil ~]$ sudo dmesg | grep firmware
phy0 -> [b]rt2x00lib[/b]_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
[ubermensch@tux-devil ~]$
[ubermensch@tux-devil ~]$ sudo ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:11:2F:41:F0:26
inet addr:192.168.0.2 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::211:2fff:fe41:f026/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:227 errors:0 dropped:0 overruns:0 frame:0
TX packets:267 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:89255 (87.1 Kb) TX bytes:41962 (40.9 Kb)
Interrupt:22 Base address:0x2c00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:280 (280.0 b) TX bytes:280 (280.0 b)
ppp0 Link encap:Point-to-Point Protocol
inet addr:79.22.18.232 P-t-P:192.168.100.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:194 errors:0 dropped:0 overruns:0 frame:0
TX packets:229 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:82907 (80.9 Kb) TX bytes:34421 (33.6 Kb)
wlan0 Link encap:Ethernet HWaddr 00:1D:0F:B0:E7:A2
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
wmaster0 Link encap:UNSPEC HWaddr 00-1D-0F-B0-E7-A2-00-00-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
[ubermensch@tux-devil ~]$
[ubermensch@tux-devil ~]$ sudo ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:2F:41:F0:26
inet addr:192.168.0.2 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::211:2fff:fe41:f026/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:223 errors:0 dropped:0 overruns:0 frame:0
TX packets:263 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:88985 (86.8 Kb) TX bytes:41716 (40.7 Kb)
Interrupt:22 Base address:0x2c00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:280 (280.0 b) TX bytes:280 (280.0 b)
ppp0 Link encap:Point-to-Point Protocol
inet addr:79.22.18.232 P-t-P:192.168.100.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:191 errors:0 dropped:0 overruns:0 frame:0
TX packets:226 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:82763 (80.8 Kb) TX bytes:34301 (33.4 Kb)
[ubermensch@tux-devil ~]$
I don't know if I have done well to use that package of AUR. In every case I pray you pointed out me the correct street...
:rolleyes:
Offline
Help me...
:rolleyes:
Offline
lsmod shows rt73, rt73usb, and rt2500usb all loaded - not good. Decide which you want to use and blacklist everything else. I used both rt73 and rt73usb myself at various times, and I'd recommend rt73usb. Don't know anything about your injection/monitor requirements though.
Offline
I've changed:
[ubermensch@tux-devil ~]$ lsmod | grep rt
parport_pc 34884 1
parport 31596 3 parport_pc,ppdev,lp
agpgart 28244 2 nvidia,intel_agp
rt73 220416 1
rtc_cmos 9120 0
rtc_core 15516 1 rtc_cmos
rtc_lib 2944 1 rtc_core
usbcore 129904 8 snd_usb_audio,snd_usb_lib,usbhid,ov51x_jpeg,rt73,ehci_hcd,uhci_hcd
[ubermensch@tux-devil ~]$
:cool:
Offline
hi! i have the same adapter, but i don't understand how to configure it to get it work, i need that package from AUR and then what should i put in rc.conf and where?
now in XP i have configured my wireless router with this
- my static IP Address
- Subnet Mask
- Default Gateway
- DHCP Server
- DNS Servers
So i need to know how to set it up the SAME way in arch, so i can download my torrents as in XP
Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.
-- Antoine de Saint-Exupery
Offline