You are not logged in.
From what I've read online, I need to put the disk into MSC mode, then when I plug it into the USB it should be automatically mounted. When I try, it's not even listed under 'fdisk -l'. When I plug in a USB flash drive, it's automatically found and mounted without problems. Do I need a special library or something?
Thanks.
e: Got it, it was because I was plugging it into a USB extension and directly into the computer.
Last edited by Yes (2008-06-06 23:37:17)
Offline
Ok, I guess that wasn't it, because it's not working anymore. I works fine in Windows and Ubuntu, so do I need add myself to a group or something?
Offline
Not sure if this is a groups problem but you could have a look here and add yourself to the relative groups http://wiki.archlinux.org/index.php/Groups
Offline
Thanks. Unfortunately, I added myself to disk and storage but, the only two groups that seem like they might be needed, but to no avail.
Offline
Can you post the output from
dmesg | tail
after plugging in the flash drive.
Offline
I'm receiving a Sansa View today and my preliminary searches have brought me to http://www.micahcarrick.com/05-21-2008/ … buntu.html - it seems to be a good manual, but of course I have not been able to test it yet.
Zl.
Offline
dmesg | tail:
it87: Found IT8718F chip at 0x290, revision 4
it87: in3 is VCC (+5V)
coretemp coretemp.0: Using undocumented features, absolute temperature might be wrong!
coretemp coretemp.1: Using undocumented features, absolute temperature might be wrong!
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
eth0: no IPv6 routers present
usb 7-4: new high speed USB device using ehci_hcd and address 3
ehci_hcd 0000:00:1a.7: port 4 reset error -110
hub 7-0:1.0: hub_port_status failed (err = -32)
I'll take a look at that page now zenlord, thanks.
e: I tried putting it in hold and pressing the left button for five seconds like the page said, but it didn't do anything. Thanks, though.
Last edited by Yes (2008-06-13 15:18:06)
Offline
Do "rmmod ehci-hcd" and it should go.
Offline
Yes!!!
Thank you, that worked
Offline