You are not logged in.
Hey all,
I rented a SpyderX from a local rental to calibrate my laptop screen and external screens.
I measured and profiled for a 6500K color temperature at 200cd/m² at Gamma 2.2.
After measuring all three screens, two identical external screens and the built in one, I tried applying the created ICC profile
in Plasma's System Settings under Display Configuration, but it results in heavy artifacts on the screen.
Under XOrg, applying through color management works fine for the built in display. The external displays
don't work under X because I'm using an eGPU (a GTX1060) setup which only works properly under Wayland.
Under X it uses the laptop's GPU, a Quadro P1000 which uses the same drivers, so there shouldn't be any differences there,
though only the embedded display works then.
Running linux 6.19.9-arch1-1 with Nvidia drivers 580.142 (the nvidia-580xx-dkms package).
Picture of two screens, the bottom one has the ICC profile applied (both should be same brightness):
https://imgur.com/a/czH1yGf
All screens show the same type of artifact when their ICC profile is applied to them
I should note, under X11 with the working ICC profile applied, Darktable distorts images in a similar way when
"System display profile" or the imported ICC is selected for the display profile. Choosing anything else
works fine.
Last edited by OrakMoya (Yesterday 18:38:16)
Offline