You are not logged in.
Pages: 1
Hi,
I want to connect two monitors on laptop, one with hdmi and second with vga cable. When system boot on monitor with hdmi resolution is correct 1366x768, but on vga max resolution is 1024x768.
After running the commands below everything works fine.
xrandr --newmode "1368x768_60.00" 85.25 1366 1440 1576 1784 768 771 781 798 -hsync +vsync
xrandr --addmode VGA1 1368x768_60.00
xrandr --output VGA1 --mode 1368x768_60.00
Screen 0: minimum 8 x 8, current 2732 x 768, maximum 32767 x 32767
DP1 disconnected primary (normal left inverted right x axis y axis)
HDMI1 connected 1366x768+0+0 (normal left inverted right x axis y axis) 700mm x 390mm
1366x768 59.79*+
1920x1080 60.00 50.00 59.94 30.00 25.00 24.00 29.97 23.98
1920x1080i 60.00 50.00 59.94
1280x720 60.00 50.00 59.94
1024x768 75.03 70.07 60.00
832x624 74.55
800x600 72.19 75.00 60.32
720x576 50.00
720x576i 50.00
720x480 60.00 59.94 59.94
720x480i 60.00 59.94
640x480 75.00 72.81 66.67 60.00 59.94
720x400 70.08
VGA1 connected 1366x768+1366+0 (normal left inverted right x axis y axis) 0mm x 0mm
1366x768 59.88 +
1024x768 60.00
800x600 60.32 56.25
848x480 60.00
640x480 59.94
1368x768_60.00 59.88*
VIRTUAL1 disconnected (normal left inverted right x axis y axis)
I use dwm with lightdm display manager. Is it possible to automate this process on startup?
Sorry for bad english
Thanks.
Last edited by grobar87 (2024-04-27 21:58:30)
And... here... we... go!
Offline
Online
I followed the wiki and everything works great now.
Thanks.
Last edited by grobar87 (2024-04-27 21:58:08)
And... here... we... go!
Offline
Pages: 1