Arch Linux

tsavannah

Member

Registered: 2009-07-07

Posts: 2

archiso no longer auto-mounts drive

I'm using a custom installation with archiso..

It used to boot and auto-mount the drive with archisolabel="XXX" (where XXX is the drive label) to /bootmnt

Now, updating to newest archiso-git it always brings me into maintanence mode (cannot mount drive at /dev/disk/by-label/arch)

Typing "mount /dev/disk/by-label/arch /bootmnt; exit" works and finishes the init.

I've tried setting the drive label on this -- however the new archiso doesn't seem to support that:

[root@image64 iso]# tune2fs -L arch /dev/sdc1
tune2fs 1.41.9 (22-Aug-2009)
tune2fs: Bad magic number in super-block while trying to open /dev/sdc1
Couldn't find valid filesystem superblock.

Any ideas what I'm missing here?