You are not logged in.
- Topics: Active | Unanswered
#1 2010-09-16 09:53:36
- Goophy
- Member
- Registered: 2005-09-21
- Posts: 34
No signal to second monitor with Nouveau-driver. [Solved]
When I load the Nouveau with KMS the signal to the second monitor disappears.
Without KMS the driver won't work at all.
Xrandr says both monitors are connected.
Anyone know what's happening? Everything seems to work correctly, but no signal is going out to the second monitor.
Both monitors display everything from boot till the modules is loaded, then the signal is gone.
Edit: I've tried with different modes (nomodeset, 1 etc.).
Last edited by Goophy (2010-09-16 21:06:05)
Offline
#2 2010-09-16 12:02:10
- Goophy
- Member
- Registered: 2005-09-21
- Posts: 34
Re: No signal to second monitor with Nouveau-driver. [Solved]
Of course it was faulty hardware.
Offline
#3 2010-09-16 18:05:32
- ngoonee
- Forum Fellow
- From: Between Thailand and Singapore
- Registered: 2009-03-17
- Posts: 7,362
Re: No signal to second monitor with Nouveau-driver. [Solved]
Would appreciate if you marked the thread [solved].
Allan-Volunteer on the (topic being discussed) mailn lists. You never get the people who matters attention on the forums.
jasonwryan-Installing Arch is a measure of your literacy. Maintaining Arch is a measure of your diligence. Contributing to Arch is a measure of your competence.
Griemak-Bleeding edge, not bleeding flat. Edge denotes falls will occur from time to time. Bring your own parachute.
Offline