Arch Linux

gatchan

Member

From: Liège - Belgique

Registered: 2011-07-12

Posts: 22

Iomega portable HD don't work on USB3

Hello all,

   I buy a Iomega portable HD (prestige) USB2/3. It work perfectly on my USB2 connector, but it's not recognized on my USB3 connector.
   HP Elitebook 8540p (fresh ArchLinux install-KDE, up to date).

dmesg output:

[ 1199.429409] usb 1-1: USB disconnect, device number 2
[ 1202.659071] usb 2-2: new SuperSpeed USB device number 2 using xhci_hcd
[ 1202.699495] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.705842] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.711996] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.718213] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.749344] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.756596] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1202.963477] xhci_hcd 0000:45:00.0: WARN no SS endpoint bMaxBurst
[ 1203.013538] xhci_hcd 0000:45:00.0: WARN: short transfer on control ep
[ 1203.013930] scsi6 : uas
[ 1203.022145] scsi 6:0:0:0: Direct-Access     OEM      Ext Hard Disk    0000 PQ: 0 ANSI: 5
[ 1203.022429] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 1203.234045] sd 6:0:0:0: [sdb] 244011446 4096-byte logical blocks: (999 GB/930 GiB)
[ 1203.283112] scsi 6:0:0:1: CD-ROM            Virtual  CDROM                 PQ: 0 ANSI: 0
[ 1203.473039] sr1: scsi-1 drive
[ 1203.473224] sr 6:0:0:1: Attached scsi CD-ROM sr1
[ 1203.473351] sr 6:0:0:1: Attached scsi generic sg3 type 5
[ 1203.473420] usbcore: registered new interface driver uas
[ 1203.522348] sd 6:0:0:0: [sdb] Write Protect is off
[ 1203.522356] sd 6:0:0:0: [sdb] Mode Sense: 00 00 00 00
[ 1203.615772] sd 6:0:0:0: [sdb] Cache data unavailable
[ 1203.615777] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 1203.715643] xhci_hcd 0000:45:00.0: WARN: babble error on endpoint
[ 1203.715890] xhci_hcd 0000:45:00.0: WARN Set TR Deq Ptr cmd invalid because of stream ID configuration
[ 1203.715993] xhci_hcd 0000:45:00.0: ERROR Transfer event for disabled endpoint or incorrect stream ring

Thanks for your help