Arch Linux

aerophibian

Member

Registered: 2011-09-30

Posts: 3

I can't add a printer

Hi!

I installed the cups and then I added the cupsd to daemon and it starts fine now, but when I uses the hplip configuration wizard, the following error appears:

"Printer queque setup failed

ls user added to sys group"

Also, when I click on "Add Printer" in CUPS page, it gives a error: "forbidden".

Thanks for the help and sorry my english.

Last edited by aerophibian (2011-10-01 23:12:28)

lagagnon

Member

From: an Island in the Pacific...

Registered: 2009-12-10

Posts: 1,087

Website

Re: I can't add a printer

Did you try using cups itself to configure the printer (ie from your browser to localhost:631) rather than the hplip config wizard?

---

Philosophy is looking for a black cat in a dark room. Metaphysics is looking for a black cat in a dark room that isn't there. Religion is looking for a black cat in a dark room that isn't there and shouting "I found it!". Science is looking for a black cat in a dark room with a flashlight.

spookyln

Member

From: Czech Rep

Registered: 2009-02-10

Posts: 39

Re: I can't add a printer

Just try demoversion of TurboPrint2 in AUR or newest version from TP2 website.
I'm using this soft long time without any prob.