You are not logged in.
Pages: 1
I'm trying to install a UCA202 on archlinux, but when I plug it on usb port, dmesg shows me:
[67012.513370] hub 4-0:1.0: unable to enumerate USB device on port 3
[67023.633369] hub 4-0:1.0: unable to enumerate USB device on port 3
[67072.963380] hub 4-0:1.0: unable to enumerate USB device on port 3I've had the same problem with an external hard disk and disabling ehci_hcd was enough to make it work.
Also, snd_usb_audio is loaded.
I've tested it on others two computers: one running archlinux and I've got the same error and other running windows, which worked nice. This makes me think it's a kernel thing.
Last edited by Helljawz (2012-01-14 18:06:32)
Offline
Were you able to resolve this? I was just looking into picking up one of these.
Offline
No, I couldn't fix this issue. ![]()
Offline
Is this sound card known to be supported by linux?
Offline
Is this sound card known to be supported by linux?
Yes i've had one for years, even used it on a Synology NAS (kernel 2.6.18). ![]()
ᶘ ᵒᴥᵒᶅ
Offline
No, I couldn't fix this issue.
That's too bad! I actually got mine yesterday.
It's working just fine and sounds much better than my internal audio.
Here's my dmesg:
[ 792.460007] usb 6-4: new full-speed USB device number 5 using ohci_hcd
[ 792.628701] input: Burr-Brown from TI USB Audio CODEC as /devices/pci0000:00/0000:00:12.0/usb6/6-4/6-4:1.3/input/input14
[ 792.628810] generic-usb 0003:08BB:2902.0005: input,hidraw2: USB HID v1.00 Device [Burr-Brown from TI USB Audio CODEC ] on usb-0000:00:12.0-4/input3
[ 792.768046] usbcore: registered new interface driver snd-usb-audioOffline
Pages: 1