You are not logged in.
- Topics: Active | Unanswered
#1 2012-04-11 14:27:49
- sundar_ima
- Member
- Registered: 2011-03-14
- Posts: 45
[Solved] Gambas3 not working after installation.
When gambas3 was released i downloaded source and installed in my arch machine with out knowing that same package is available in arch repo. After install i could open and work in gambas3 with out an issue. However, When gambas3.1 was released i downloaded and installed latest package from arch repo. This time gambas3 did not even open. I also would like to inform that i have not uninstalled gambas3 (installed from source) before installing gambas3.1. Any help is appreiciated...
Last edited by sundar_ima (2012-04-14 02:39:36)
Offline
#2 2012-04-11 17:04:55
- Gcool
- Member
- Registered: 2011-08-16
- Posts: 1,456
Re: [Solved] Gambas3 not working after installation.
"Did not open" is not exactly a proper problem description. In order to get any useful help/advice here you'll need to be more specific. What error do you get when you launch it (via cli), what do the logs say, etc etc
Burninate!
Offline
#3 2012-04-12 01:30:28
- sundar_ima
- Member
- Registered: 2011-03-14
- Posts: 45
Re: [Solved] Gambas3 not working after installation.
Here is what i get if i run gambas3 from cli.
ERROR: #2: Cannot load class 'Container': Cannot load parent class: Cannot load class 'Control': Unable to load class file
Segmentation faultOffline
#4 2012-04-12 09:49:53
- Gcool
- Member
- Registered: 2011-08-16
- Posts: 1,456
Re: [Solved] Gambas3 not working after installation.
Try checking if the permissions on your /usr/share/gambas3 (and underlying) folders are correct.
Burninate!
Offline
#5 2012-04-12 14:17:52
- sundar_ima
- Member
- Registered: 2011-03-14
- Posts: 45
Re: [Solved] Gambas3 not working after installation.
Ok. I have checked those folders and sub folders and it is root (user and group). When i tried opening gambas with sudo, i did not get second line error "Segmentation fault".
Offline
#6 2012-04-12 14:31:37
- sundar_ima
- Member
- Registered: 2011-03-14
- Posts: 45
Re: [Solved] Gambas3 not working after installation.
Thank you Gcool for the help. I got it rectified by uninstalling gambas3 source installation (sudo make uninstall). Then reinstalled gambas3 from repo.
Offline
#7 2012-04-12 17:53:14
- Gcool
- Member
- Registered: 2011-08-16
- Posts: 1,456
Re: [Solved] Gambas3 not working after installation.
Good to hear you've got it up and running.
Don't forget to mark your thread as [SOLVED].
Burninate!
Offline