You are not logged in.

#1 2012-07-23 02:38:46

FathisAeril
Member
Registered: 2010-07-02
Posts: 82

Arch + KDE + HDMI Cable to TV & Resolutions

Hey guys, got a new laptop so I wanted to set my old one up as a media center PC to my TV, as well as a few other things since the new one is less powerful than the old one (Dropped a Desktop Replacement for an Ultrabook. God I love the better battery life and less weight xD )

Since I am running Arch on it, and plan to keep up with updates, I didn't want to install Catalyst and deal with Xorg updates breaking it, i'm going with the Radeon driver. Ignoring possible HDMI Audio issues, I already know about those, and will deal with them when I cross that bridge.

Now onto the issue. I plugged in my HDMI cable to my TV and Laptop, KDE detected it, popped open the display config. My laptop's native resolution is 1600x900, the TV (HDMI-0) is defaulting to 1360x768, but KDE allows me to go up to 1920x1080 so I know it can go higher than the 1360x768. The problem is KDE doesnt have an option for 1600x900 for HDMI-0. And if I pick "Unify Outputs" it drops both screens back to 1280x720. I was following the wiki article on Xrandr,  running 'xrandr' returns all the possible values for HDMI-0 that KDE knows of as well. I just need to know  to add an additional one for HDMI-0 that allows for 1600x900. And running something like what the wiki has:

  xrandr --newmode "1280x1024_60.00"  109.00  1280 1368 1496 1712  1024 1027 1034 1063 -hsync +vsync 

without knowing what all of the parameters mean doesnt seem too smart, I'd hate to screw up my TV by experimenting without good reason.

So does anyone have any ideas of what I can do to allow me to output 1600x900 over HDMI?


It doesn't matter how much training you have. A broken rib is still a broken rib.

Offline

#2 2012-07-23 04:36:29

velusip
Member
Registered: 2010-12-01
Posts: 18

Re: Arch + KDE + HDMI Cable to TV & Resolutions

The best I can do to help is suggest some reading material.  There are 2 pieces of info required:  supported display modes and an xrandr command.

1.  Confirm the supported modes of your television first.  It's an old habit from the bad-old days when you could ruin a CRT with bad input.  It is likely that you will see a user-friendly "unsupported mode" message displayed on your screen if you throw a screwball at it.  Check the manufacturer's website for support material if you do not have a manual stating resolution/frequency information.  Make and model number should be tagged somewhere.

2.  Now you have a list of modes you can properly form an xrandr command.  Spend some time with the man page.  You already have a good example to start from, all you really need to do is fill in precisely the supported resolutions and frequencies.

Offline

Board footer

Powered by FluxBB