You are not logged in.
Hello out there,
After a fresh installation of my Arch Linux box, I want to use e17.
Everything works fine, except that e17 does not take over the german keyboard layout that I configured for X.
This is the content of my /etc/X11/xorg.conf.d/20-keyboard.conf:
Section "InputClass"
Identifier "keyboard"
MatchIsKeyboard "yes"
Option "XkbLayout" "de"
Option "XkbVariant" "nodeadkeys"
EndSectionUnder XDM, I can enter Umlauts and everything is fine. In e17, this is not the case.
I am sure that I already had this problem in the past but I can't remember the solution.
Any ideas?
EDIT: Now I put this in the file 10-evdev.conf, but with still no more effect.
Section "InputClass"
Identifier "evdev keyboard catchall"
MatchIsKeyboard "on"
MatchDevicePath "/dev/input/event*"
Driver "evdev"
Option "XkbLayout" "de"
Option "XkbVariant" "nodeadkeys"
EndSectionLast edited by beachcoder (2012-07-24 07:00:00)
Offline
Ah, I now found out:
All to do is: Activate the Module "XKBSwitch" in the Enlightenment module settings, then in the Settings panel go to Input, call "XKB Switcher", remove English and add German, and all is fine.
I thought that it was easy!
Offline
Solved only for basic variants of keyboard layouts. I use 'cz qwerty', but no option for this xkbmap variant is icluded into XKBSwitch module. Loading this variant manually via setxkbmap command is possible'but annoying... There is no support for XKB variants in e17 when X used and supported by e17 provide the job reliably but of extraordinary way for e17 configuration.
Our tomcat for your mice! Archlinux for your comps! Alfa Romeo for your roads! Faster running guaranted!
Offline