You are not logged in.

#1 2012-10-22 02:28:29

badhat
Member
Registered: 2011-01-30
Posts: 112

[SOLVED]X loads a blank screen or a screen with white/black lines

####EDIT#####
Marked as [SOLVED] because current kernels seem to work just fine.

Most of the time the system works just fine. LightDM and XFCE for desktop on top of XORG with the open source radeon driver. The graphics are the AMD APU (A6 3650).

Occasionally, the system will reboot (or cold boot) and will end up with black/white vertical lines. Sometimes it is just a blank screen instead. I'm using the Liquorix kernel, however the same issue occurs with the generic distribution kernel. And, like I said, sometimes it boots cleanly without any issue at all.

From /var/log/dmesg:

[drm] Initialized drm 1.1.0 20060810
[drm] radeon kernel modesetting enabled.
checking generic (d0000000 3aa000) vs hw (d0000000 10000000)
fb: conflicting fb hw usage radeondrmfb vs EFI VGA - removing generic driver
Console: switching to colour dummy device 80x25
[drm] initializing kernel modesetting (SUMO 0x1002:0x964A 0x1043:0x84C8).
[drm] register mmio base: 0xFEB00000
[drm] register mmio size: 262144
ATOM BIOS: General
radeon 0000:00:01.0: VRAM: 512M 0x0000000000000000 - 0x000000001FFFFFFF (512M used)
radeon 0000:00:01.0: GTT: 512M 0x0000000020000000 - 0x000000003FFFFFFF
[drm] Detected VRAM RAM=512M, BAR=256M
[drm] RAM width 32bits DDR
[TTM] Zone  kernel: Available graphics memory: 3815778 kiB
[TTM] Zone   dma32: Available graphics memory: 2097152 kiB
[TTM] Initializing pool allocator
[TTM] Initializing DMA pool allocator
[drm] radeon: 512M of VRAM memory ready
[drm] radeon: 512M of GTT memory ready.
[drm] Supports vblank timestamp caching Rev 1 (10.10.2010).
[drm] Driver supports precise vblank timestamp query.
radeon 0000:00:01.0: irq 53 for MSI/MSI-X
radeon 0000:00:01.0: radeon: using MSI.
[drm] radeon: irq initialized.
[drm] GART: num cpu pages 131072, num gpu pages 131072
[drm] Loading SUMO Microcode
[drm] PCIE GART of 512M enabled (table at 0x0000000000040000).
radeon 0000:00:01.0: WB enabled
radeon 0000:00:01.0: fence driver on ring 0 use gpu addr 0x0000000020000c00 and cpu addr 0xffff880204e03c00
[drm] ring test on 0 succeeded in 1 usecs
[drm] ib test on ring 0 succeeded in 0 usecs
[drm] Radeon Display Connectors
[drm] Connector 0:
[drm]   VGA-1
[drm]   HPD2
[drm]   DDC: 0x6440 0x6440 0x6444 0x6444 0x6448 0x6448 0x644c 0x644c
[drm]   Encoders:
[drm]     CRT1: INTERNAL_UNIPHY2
[drm]     CRT1: NUTMEG
[drm] Connector 1:
[drm]   DVI-D-1
[drm]   HPD1
[drm]   DDC: 0x6430 0x6430 0x6434 0x6434 0x6438 0x6438 0x643c 0x643c
[drm]   Encoders:
[drm]     DFP1: INTERNAL_UNIPHY2
[drm] Internal thermal controller without fan control
[drm] radeon: power management initialized
[drm] fb mappable at 0xD0142000
[drm] vram apper at 0xD0000000
[drm] size 5242880
[drm] fb depth is 24
[drm]    pitch is 5120
fbcon: radeondrmfb (fb0) is primary device
[drm:radeon_dp_link_train_ce] *ERROR* channel eq failed: 5 tries
[drm:radeon_dp_link_train_ce] *ERROR* channel eq failed
NET: Registered protocol family 10
[drm:atom_op_jump] *ERROR* atombios stuck in loop for more than 5secs aborting
[drm:atom_execute_table_locked] *ERROR* atombios stuck executing E262 (len 2585, WS 4, PS 4) @ 0xE94C
Console: switching to colour frame buffer device 128x48
fb0: radeondrmfb frame buffer device
drm: registered panic notifier
[drm] Initialized radeon 2.24.0 20080528 for 0000:00:01.0 on minor 0

Of course, I have the full /var/log/messages but I am not sure what the issue is. I notice that my monitors have different names in these files from what they are called by XRANDR (VGA-0 and DVI-0). Is this related?

Last edited by badhat (2013-06-01 18:54:45)

Offline

#2 2012-10-22 03:35:26

arctos
Member
Registered: 2010-12-19
Posts: 13

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

Same here.
I also use an APU with 6310 video card and radeon drivers

Offline

#3 2012-10-22 06:20:55

Ricepicker
Member
Registered: 2011-10-08
Posts: 7

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

Try disable KMS that stopped my blank reboots. Not sure about the lines though.

Offline

#4 2012-10-22 19:56:29

badhat
Member
Registered: 2011-01-30
Posts: 112

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

That is unfortunate. I've tried (I used to) setting KMS to disabled by adding "nomodeset" as a boot parameter to my kernel. The issue was still happening when I did this (white/black lines or blank screen).

Glad to see that I am not alone with this issue and the AMD APUs. This narrows the problem down a little more. Other ideas?

Offline

#5 2012-10-31 12:56:24

klausenbusk
Member
Registered: 2012-08-04
Posts: 16

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

I can also confirm i have this issus, will try when i get weekend to ssh into my laptop and try to get the screen to work.
I report back smile

Last edited by klausenbusk (2012-10-31 12:57:18)

Offline

#6 2012-10-31 15:00:26

senorsmile
Member
Registered: 2010-12-12
Posts: 72

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

I also have this issue. In fact, as of this morning, my laptop won't boot regularly.  I have tried several times.

Offline

#7 2012-11-01 22:59:19

badhat
Member
Registered: 2011-01-30
Posts: 112

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

Kernel 3.2 does not seem to be affected. That is, when I choose to boot a kernel below the 3.6.x and 3.4.x series I am unaffected. It was mentioned that turning off KMS might solve this (I tried with "nomodeset" as a boot parameter) -- though turning it off did not help in my case, it does seem to have some merit. Others have reported success.

Offline

#8 2012-11-02 07:48:43

klausenbusk
Member
Registered: 2012-08-04
Posts: 16

Re: [SOLVED]X loads a blank screen or a screen with white/black lines

badhat wrote:

Kernel 3.2 does not seem to be affected. That is, when I choose to boot a kernel below the 3.6.x and 3.4.x series I am unaffected. It was mentioned that turning off KMS might solve this (I tried with "nomodeset" as a boot parameter) -- though turning it off did not help in my case, it does seem to have some merit. Others have reported success.

Not sure but maybe kernel 3.7 fix it, there have been some changes in "radeon": http://www.phoronix.com/scan.php?page=n … px=MTE5Nzg
Have you any option to try with kernel 3.7? (i could maybe try later today..)

Last edited by klausenbusk (2012-11-02 07:51:47)

Offline

Board footer

Powered by FluxBB