You are not logged in.
I stuck a toe into the Conky waters recently, and discovered a weirdness when listing my internal IP:
The pertinent section of my .conkyrc is this:
${else}${if_existing /proc/net/route eth0}
${voffset -6}${font PizzaDude Bullets:size=14}O${font} Up: ${upspeed eth0} kb/s ${alignr}${upspeedgraph eth0 8,60 FFFFFF FFFFFF}
${voffset 4}${font PizzaDude Bullets:size=14}U${font} Down: ${downspeed eth0} kb/s ${alignr}${downspeedgraph eth0 8,60 FFFFFF FFFFFF}
${voffset 4}${font PizzaDude Bullets:size=14}N${font} Upload: ${alignr}${totalup eth0}
${voffset 4}${font PizzaDude Bullets:size=14}T${font} Download: ${alignr}${totaldown eth0}
${voffset 4}${font PizzaDude Bullets:size=14}a${font} eth0 Local IP: ${alignr}${addr eth0}Conky displays "192.168.0.126"
ifconfig says my internal IP is: "192.168.0.101" -- which I would deem "correct" based on how I set up the system
/proc/net/route eth0 reveals multiple "eth0" entries:
Iface Destination Gateway Flags RefCnt Use Metric Mask MTU Window IRTT
tun0 00000000 0550800A 0003 0 0 0 00000000 0 0 0
eth0 00000000 0100A8C0 0003 0 0 202 00000000 0 0 0
tun0 0150800A 0550800A 0007 0 0 0 FFFFFFFF 0 0 0
tun0 0550800A 00000000 0005 0 0 0 FFFFFFFF 0 0 0
eth0 CC711732 0100A8C0 0007 0 0 0 FFFFFFFF 0 0 0
eth0 0000A8C0 00000000 0001 0 0 202 00FFFFFF 0 0 0
When I change "addr" to "addrs" in the .conkyrc, .101 is listed first, follow by a comma, then another IP that flows off the right edge of the conky window (I'm assuming it could be the .126 one)...
Why do I have multiple eth0's in /proc/net/route--and is there a cleaner way to list the .101 in conky without resorting to the 'addrs' option?
Hey, be nice...I'm new at this!
Offline