You are not logged in.

#1 2013-01-09 19:10:31

fawkes5
Member
From: Canada
Registered: 2012-12-23
Posts: 84

Trayer does not Adjust correctly when Switching to External Monitor

Hello

I use a laptop with xmonad and xmobar and trayer. When i connect my external monitor via VGA, i set it to primary. My xmobar moves perfectly to the top of my external monitor, with a width of 90% of the screen, as specified in my xmobarrc. However, trayer acts differently. It does move to my external monitor, however, its position overlaps with xmobar, and does not move correctly to the remaining 10% of the screen left by xmobar which i would like trayer to occupy.

How can i make trayer move correctly?

Thank you!

Last edited by fawkes5 (2013-01-09 19:10:51)

Offline

#2 2013-01-09 19:26:16

fawkes5
Member
From: Canada
Registered: 2012-12-23
Posts: 84

Re: Trayer does not Adjust correctly when Switching to External Monitor

Hello again. If i start my external monitor when i startx (i.e through .xinitrc) then it sets correctly. So its just the dyanmic changing of resolution that trayer has trouble adjusting with.

Last edited by fawkes5 (2013-01-11 00:35:28)

Offline

#3 2013-01-11 00:34:44

fawkes5
Member
From: Canada
Registered: 2012-12-23
Posts: 84

Re: Trayer does not Adjust correctly when Switching to External Monitor

Hello.

My second post is a 'good-enough' solution for me and i am no longer activly seeking a solution to the more general problem.

Thank you

Offline

Board footer

Powered by FluxBB