You are not logged in.

#1 2013-03-06 17:03:13

Reded
Member
From: Manchester, England
Registered: 2012-02-21
Posts: 242

Gnome Shell boots into 'Fallback' Mode [SOLVED]

Hey all!

I've been keeping my eye on Gnome 3, and decided to install it myself to give 3.6 a try. However, for some reason when I start it, it loads up into the fallback mode. I basically installed all the 'gnome' and 'gnome-extras' packages as per the Wiki, and I'm running an ATI card with proprietary drivers.

I've googled around a bit and it was mentioned that for some people running 'gnome-shell --replace' fixes this, however for me this causes a black screen that I can't do anything with except move the mouse about.

As far as I can tell, my drivers are working (My games run smooth as always) so I'm not sure what else to try.

Can anyone help with this? I can't find any info online as to how to fix it!

Last edited by Reded (2013-03-06 18:12:23)


"Some humans would do anything to see if it was possible to do it. If you put a large switch in some cave somewhere, with a sign on it saying "End-of-the-World Switch. PLEASE DO NOT TOUCH", the paint wouldn't even have time to dry."

Offline

#2 2013-03-06 18:11:49

Reded
Member
From: Manchester, England
Registered: 2012-02-21
Posts: 242

Re: Gnome Shell boots into 'Fallback' Mode [SOLVED]

I've solved this by disabling Xinerama in the Catalyst Control Center - Apparently Gnome Shell only does two monitors without it!

*Marks as solved*


"Some humans would do anything to see if it was possible to do it. If you put a large switch in some cave somewhere, with a sign on it saying "End-of-the-World Switch. PLEASE DO NOT TOUCH", the paint wouldn't even have time to dry."

Offline

Board footer

Powered by FluxBB