You are not logged in.

#1 2013-03-19 11:01:09

Ploink
Member
Registered: 2011-10-26
Posts: 17

Setting up CUPS with Samba Printer with authentication

Hi,

I'm trying to connect to a network printer (Samba) using CUPS, and I'm not able to correctly set the authentication options. I have tried setting it up according to the wiki, but the problem is that my password contains an '@', and I'm not sure how to enter that into the device URI. Omitting the ":password" bit gives me "NT_STATUS_ACCESS_DENIED" or "NT_STATUS_AUTH_FAILURE" errors (as displayed on the CUPS web interface). The web interface doesn't give me the option to resolve this (actually, CUPS doesn't give me an option to enter auth credentials anywhere during the print process at all!)

I had set it up on Ubuntu earlier, and though the jobs still used to fail with an auth failure, I could access the print job from a printers icon in my system tray, which gave me an option to enter authentication information. I'm afraid I can't use the same workaround here, because I'm using Enlightenment, and I don't know what the corresponding service/module is....

Does anyone have any suggestions? Thanks!

Offline

Board footer

Powered by FluxBB