You are not logged in.

#1 2013-03-21 09:42:19

seveg
Member
From: Bratislava, Slovakia
Registered: 2012-04-17
Posts: 33

[SOLVED] Terminator in XFCE - Can't switch next/prev tab

Hi guys,

I'm running Arch in VirtualBox with XFCE and I installed Terminator terminal emulator.
Documentation says that next tab and previous tab shortcuts are Ctrl + PgUp and Ctrl + PgDown respectively, but they don't do anything.
The next_tab and prev_tab settings (Preference -> Keybindings) was disabled, so i set them to above shortcuts, but i did not help. They're still not working and when i open Preference window again, they're
disabled again..
I'm probably missing some detail, so sorry for dumb question, but I can't google anything related to this and the application is unusable without these shortcuts working.
Thank you for any advice.

G

p.s. in xfce terminal, Ctrl + PgUp and Ctrl + PgDown works fine.

Last edited by seveg (2013-03-22 08:17:21)


Just another drug abuser..

Offline

#2 2013-03-22 08:16:32

seveg
Member
From: Bratislava, Slovakia
Registered: 2012-04-17
Posts: 33

Re: [SOLVED] Terminator in XFCE - Can't switch next/prev tab

Hm, i found out that I've had these settings in ~/.config/terminator/config

[keybindings]
  next_tab = <Primary>Page_Down
  prev_tab = <Primary>Page_Up

The GUI settings obviously could not change the settings (not sure if bug or feature).. I have modified it to:

[keybindings]
  next_tab = <Ctrl>Page_Down
  prev_tab = <Ctrl>Page_Up

Now the tab switching with Ctrl + PgUp/PgDown works.


Just another drug abuser..

Offline

Board footer

Powered by FluxBB