You are not logged in.

#1 2013-04-29 06:46:06

zylex
Member
From: Slovakia/Czech rep.
Registered: 2012-08-09
Posts: 7

[SOLVED] TexLive - missing font after update

Hi, I just updated texlive* packages to newer version and since then I can't compile my files. Here is the error message:

kpathsea: Running mktexpk --mfmode / --bdpi 600 --mag 1+0/600 --dpi 600 phvr8z
mktexpk: don't know how to create bitmap font for phvr8z.
mktexpk: perhaps phvr8z is missing from the map file.
kpathsea: Appending font creation commands to missfont.log.
(see the transcript file for additional information)
!pdfTeX error: pdflatex (file phvr8z): Font phvr8z at 600 not found
 ==> Fatal error occurred, no output PDF file produced!

Font file is located as:

/usr/share/texmf-dist/fonts/tfm/cs/cs-a35/phvr8z.tfm

I played around and tried running udpmap, udpmap-sys but it is really messy for me now, so could sombody help?

Last edited by zylex (2013-04-30 11:26:57)

Offline

#2 2013-04-30 08:54:18

olive
Member
From: Belgium
Registered: 2008-06-22
Posts: 1,490

Re: [SOLVED] TexLive - missing font after update

Could you post a sample file that do not compile? Try to make such a minimal file with the less as possible.

Offline

#3 2013-04-30 11:26:06

zylex
Member
From: Slovakia/Czech rep.
Registered: 2012-08-09
Posts: 7

Re: [SOLVED] TexLive - missing font after update

Problem "solved". It's school project with lot of input files for text formatting, so I just commented few of them which caused problems and final text will be compiled on school server. Ugly, but works.

Offline

#4 2013-05-02 13:56:32

DedMaroz
Member
From: Czech Republic
Registered: 2013-05-02
Posts: 1

Re: [SOLVED] TexLive - missing font after update

Try:

updmap --enable Map=cs-a35-nodownload.map

Worked for me wink

Offline

#5 2013-05-04 23:17:36

zylex
Member
From: Slovakia/Czech rep.
Registered: 2012-08-09
Posts: 7

Re: [SOLVED] TexLive - missing font after update

Thanks! Now it's solved :-)

Offline

#6 2013-05-06 08:00:34

cocos
Member
From: Czech Republic
Registered: 2013-05-06
Posts: 5

Re: [SOLVED] TexLive - missing font after update

It's actually not solved, just worked around. Now the font is not embedded - try checking File-Properties-Fonts in Evince. For me it says "Not embedded, Substituting with..." while it was properly embedded for PDFs made before the update.

Offline

Board footer

Powered by FluxBB