You are not logged in.

#1 2013-05-14 09:26:58

ppsalama
Member
From: Spain
Registered: 2012-01-29
Posts: 79

minidlna not working after upgrade

Hi...
This morning after pacman syu my minidnla package was upgraded. I was advised about new minidlna.conf saved as pacnew. I used kompare in order to see the differences and I noticed not enough changes but my parameters. I edited the pacnew file with my parameters and renamed to minidlna.conf.
When I try to execute minidlna through my desktop shortcut as normaly (kdesu minidlna -R) I get the message "couldn't execute 'minidlna -R'". I went back to my older minidlna.conf (hoping it works) but I got the same message.
What can I do? Any ideas?
Thank you very much and sorry for my english.
Regards

Offline

#2 2013-05-14 09:35:33

Raynman
Member
Registered: 2011-10-22
Posts: 1,094

Re: minidlna not working after upgrade

Name of the executable changed to minidlnad.

Offline

#3 2013-05-14 09:36:23

arojas
Developer
From: Spain
Registered: 2011-10-09
Posts: 1,174

Re: minidlna not working after upgrade

The daemon seems to have changed its name to minidlnad in 1.1.0

Offline

#4 2013-05-14 10:05:18

ppsalama
Member
From: Spain
Registered: 2012-01-29
Posts: 79

Re: minidlna not working after upgrade

Perfect !!!! thank you both... it works...
Other question before marking this post as solved.... Usually when I executed my desktop shortcut, my samsung smart tv showed a pop up message with the friendly name that I wrote in minidlna.conf. Now no pop up. I dont know if it is an issue about config parameters.
Thanks again

Offline

Board footer

Powered by FluxBB