You are not logged in.

#1 2013-06-03 22:15:27

CyberNhull
Member
Registered: 2013-01-27
Posts: 99

Enlightenment..artifacts.

So i installed enlightenment and im currently almost finishing setting him up...the problem is i have some legacy drivers for ati mobile hd 5145 and every time i run enlightenment i need to switch off and then back on the vertical sync..if i dont when i open a terminal the screen tearing appears and i cant see anything.

Is there a way to fix this? Or at least put this process of turning off and on in automatic mode?

Thanks for the help ^^

Last edited by CyberNhull (2013-06-03 22:20:12)


If it does not kill you....It will make you smarter

Offline

#2 2013-06-03 22:19:21

Scimmia
Fellow
Registered: 2012-09-01
Posts: 13,729

Re: Enlightenment..artifacts.

Anything change if you switch between OpenGL and software rendering?

Offline

#3 2013-06-03 22:25:52

CyberNhull
Member
Registered: 2013-01-27
Posts: 99

Re: Enlightenment..artifacts.

Scimmia wrote:

Anything change if you switch between OpenGL and software rendering?

Interesting,after doing that i can open the terminology terminal now with no problems after a reboot..but if i open thunderbird or catalyst control center it gives me the tearing again

Last edited by CyberNhull (2013-06-03 22:33:13)


If it does not kill you....It will make you smarter

Offline

#4 2013-06-08 10:53:00

CyberNhull
Member
Registered: 2013-01-27
Posts: 99

Re: Enlightenment..artifacts.

I have the following erros in tty

 (WW)fglrx no matching device section for instance

and

 (WW)warning (ee) error (ni) not implemented (??) unknown

If it does not kill you....It will make you smarter

Offline

Board footer

Powered by FluxBB