You are not logged in.
For me gnome-shell+Xorg are always at 20-30%, or even more, especially when alt+tabbing between windows. This means high power consumption, laptop temperature is always high, slowness...
I don't remember this happening in 3.6, am I the only one having this problem?
00:02.1 Display controller: Intel Corporation Mobile GME965/GLE960 Integrated Graphics Controller (rev 0c)
Offline
Are you using the correct video drivers? There's a possibility you're using LLVM, which is a CPU-based renderer. GNOME uses LLVM as the replacement to fallback mode.
Offline
Are you using the correct video drivers? There's a possibility you're using LLVM, which is a CPU-based renderer. GNOME uses LLVM as the replacement to fallback mode.
Thanks but... how to know that?
Offline
Try:
lsmod | grep video
I'm not on a linux computer at the moment so I can't say for sure if that'll work.
Offline
Try:
lsmod | grep videoI'm not on a linux computer at the moment so I can't say for sure if that'll work.
I don't think GNOME can control in any way the kernel modules that are loaded.
Offline
I never said it did, but it REQUIRES to be composited, so it forces you to have something installed with 3D acceleration capabilities. If you don't have the proper drivers, it uses LLVM which is CPU-only, and that (especially on a laptop) is extremely draining on your processor.
Last edited by schmidtbag (2013-06-13 12:50:04)
Offline
uvcvideo 72921 0
videobuf2_vmalloc 3304 1 uvcvideo
videobuf2_memops 2367 1 videobuf2_vmalloc
videobuf2_core 27541 1 uvcvideo
videodev 105273 2 uvcvideo,videobuf2_core
media 10309 2 uvcvideo,videodev
i2c_core 22479 5 drm,i915,drm_kms_helper,i2c_algo_bit,videodev
video 11138 1 i915
usbcore 177091 5 uhci_hcd,uvcvideo,ehci_hcd,ehci_pci,usbhidIn KDE compositing works correctly. It worked good in GNOME 3.6 too.
Offline
Right, that's the point of LLVM - so compositing will work without a proper GPU setup. However, it does appear you are using the Intel drivers anyway, so that probably isn't the issue right now. Does KDE eat up a lot of CPU cycles? Also, did you enter anything xorg.conf related?
Offline
When using KDE, I see no especially high CPU use in X or kwin. I don't have a xorg.conf file.
Offline
Hmm this is getting to be more tricky. Are gnome and kde installed on the same Arch setup? They could be somehow conflicting with each other, though I don't know why; they shouldn't. I don't use gnome myself so I'm not too sure what a probable cause would be other than LLVM forcing itself to be used. Apparently you're not alone with this problem, here's a topic on the fedora forums:
http://forums.fedoraforum.org/showthread.php?t=285415
According to that, it seems the OP has intel drivers and they're not being used. Just doing a google search on "gnome high cpu usage", there's a lot of relevant results. I could look deeper into it but I figure you'd be faster at it than me at this point.
Offline
Try this
glxinfo | grep rendering
It should say => direct rendering: Yes Then check the following
glxinfo | grep OpenGL That would indicate if you're using the appropriate drivers.
If it says Gallium0.4 on llvmpipe you're using software rendering.
Offline