You are not logged in.
Pages: 1
Topic closed
I have followed the directions on the arch wiki (https://wiki.archlinux.org/index.php/CUPS#GNOME)
to set up printing. I have installedthe drivers for my shared network printers (HP Laserjet 1022n and
C3270 Photosmart); installed cups and libcups and I go into the printer settings of gnome-shell to
get the error: "Sorry! The printing service doesn't seem to be available."
Googling gets me this link (https://bbs.archlinux.org/viewtopic.php?id=134598), which suggests starting
the cups service using rc.d. However,my Arch install seems to have no idea what rc.d is.
Further searching gets me here (https://bbs.archlinux.org/viewtopic.php?id=146154), which tells me to
activate cups by doing "systemctl enable cups.service". This gives me no error but the gnome printer setup
still offers me no help.
Some more searching tells me to install and run hp-setup, which launches a GUI that finds both of my printers
using JetsetDirect (yay) and lets me configure them (yay) and then fails, telling me it is unable to connect to
the cups server; I am offered no further information or opportunity to rectify the problem (BOO).
Further background on my setup: the network printers in question are connected by USB to a wifi hub
(Airport Extreme). I have two other linux distros on this same laptop (Ubuntu/Gnome shell) and they both
identify the printers immediately and print test pages without complaint.
Your insight is truly appreciated.
Many thanks in advance.
EB
Offline
What's the output of `systemctl status cups'?
Offline
I had this exact problem today. It turns out that cups wasn't installed even though I could've sworn it was. (I don't remember why I thought this). So I installed cups with
pacman -S cups, started cups with
systemctl start cupsand allowed it to run at startup with
systemctl enable cups.
After this the printing service should be available. And by the way, the reason the rc.d instructions didn't work is that those instructions are outdated, arch moved to systemd from the old init system relatively recently.
Offline
also make sure the cups.socket is active:
systemctl enable cups.socketthat socket starts the cups.service automatically as it´s requested, so you can leave cups.service disabled.
Offline
Please note that the service name changed to org.cups.cupsd.service, i.e.
sudo systemctl enable org.cups.cupd.service
sudo systemctl start org.cups.cupd.serviceI found out about this from: http://unix.stackexchange.com/questions … ps-service
The change occurred some time prior to ARCH 4.2.5-1.
Offline
@akgrant0710
Your commands missed a "s", took me several minutes to figure out.
So the correct command should be:
sudo systemctl enable org.cups.cupsd.service
sudo systemctl start org.cups.cupsd.serviceLast edited by flockyrocky (2017-04-04 06:48:12)
Offline
Please don't necrobump: https://wiki.archlinux.org/index.php/Co … bumping.22
This information is on the wiki.
Closing
Offline
Pages: 1
Topic closed