You are not logged in.
So here's the issue. I have two displays, AOC F22, 1080P, LCD monitor which I use as the main display connected via DVI cable to NVIDIA GTX 260 graphics card. The second is my old LCD TV which has a resolution of 1366x768 @ 60 Hz which is connected via VGA cable as it doesn't have DVI port and my graphics card doesn't have a HDMI output. Now, I have installed official propreitary drivers from NVIDIA. I did nvidia-xconfi and it generated a xorg.conf file. Then, I went through the dual monitor page of the Arch Wiki & configured the 10-monitors.conf file too.
The xorg.conf file is
# nvidia-xconfig: X configuration file generated by nvidia-xconfig
# nvidia-xconfig: version 304.88 (buildmeister@swio-display-x86-rhel47-06) Wed Mar 27 15:32:58 PDT 2013
Section "ServerLayout"
Identifier "Layout0"
Screen 0 "Screen0"
InputDevice "Keyboard0" "CoreKeyboard"
InputDevice "Mouse0" "CorePointer"
EndSection
Section "Files"
EndSection
Section "InputDevice"
# generated from default
Identifier "Mouse0"
Driver "mouse"
Option "Protocol" "auto"
Option "Device" "/dev/psaux"
Option "Emulate3Buttons" "no"
Option "ZAxisMapping" "4 5"
EndSection
Section "InputDevice"
# generated from default
Identifier "Keyboard0"
Driver "kbd"
EndSection
Section "Monitor"
Identifier "Monitor0"
VendorName "Unknown"
ModelName "Unknown"
HorizSync 28.0 - 33.0
VertRefresh 43.0 - 72.0
Option "DPMS"
EndSection
Section "Device"
Identifier "Device0"
Driver "nvidia"
VendorName "NVIDIA Corporation"
EndSection
Section "Screen"
Identifier "Screen0"
Device "Device0"
Monitor "Monitor0"
DefaultDepth 24
SubSection "Display"
Depth 24
EndSubSection
EndSection
and the 10-monitor.conf
Section "ServerLayout"
Identifier "DualScreen"
Screen 0 "Screen0"
Screen 1 "Screen1" RightOf "Screen0" #Screen1 at the right of Screen0
Option "TwinView" "1" #To move windows between screens
EndSection
Section "Monitor"
Identifier "Monitor0"
Option "Enable" "true"
EndSection
Section "Monitor"
Identifier "Monitor1"
Option "Enable" "true"
EndSection
Section "Device"
Identifier "Device0"
Driver "nvidia"
Screen 0
EndSection
Section "Device"
Identifier "Device1"
Driver "nvidia"
Screen 1
EndSection
Section "Screen"
Identifier "Screen0"
Device "Device0"
Monitor "Monitor0"
DefaultDepth 24
Option "TwinView" "1"
SubSection "Display"
Depth 24
Modes "1920x1080_60.00"
EndSubSection
EndSection
Section "Screen"
Identifier "Screen1"
Device "Device1"
Monitor "Monitor1"
DefaultDepth 24
Option "TwinView" "1"
SubSection "Display"
Depth 24
Modes "1366x768_60.00"
EndSubSection
EndSection
But all i get on the LCD TV is a blank display and nothing else. I'm running GNOME 3 and everything is updated on a 64-bit system. Can somebody figure this out?
Offline