You are not logged in.
I am not sure why, I use user wired inet than wireless, but as of recently (maybe at the time of the change from netcfg to netctl) my conky setup fails to hide the wired info and replace it with the wireless one. Can it be ifplug related and as such the eth0 actually never goes down?
The code I am using right now is the following,
${if_up eth0}Local IP $alignr${addr eth0}
# External IP $alignr${execi 1 ~/.scripts/ip.sh}
Inbound $alignr ${downspeedf eth0} KB/s
Total Down ${totaldown eth0}
Outbound $alignr ${upspeedf eth0} KB/s
Total Up ${totalup eth0}${endif}
${if_up wlan0}Local IP $alignr ${addr wlan0}
# External IP $alignr${execi 1 ~/.scripts/ip.sh}
Signal ${wireless_link_qual wlan0}%
Inbound $alignr ${downspeedf wlan0} KB/s
Total Down ${totaldown wlan0}
Outbound $alignr ${upspeedf wlan0} KB/s
Total Up ${totalup wlan0}${endif}Any help in order to achieve the expected result would be much appreciated.
\(o_X)/
'Cause I wanna be an Archy - An Archy in the UK // Sex Pistols
Offline