You are not logged in.

#1 2013-10-04 16:01:26

Unia
Member
From: Stockholm, Sweden
Registered: 2010-03-30
Posts: 2,486
Website

[SOLVED] Setting up a secondary monitor

Hey,

I want to set up a (temporary) secondary monitor for my new laptop (which has Intel graphics). On my old laptop (which has ATI graphics) I had two separate screens that I could move applications between (and both had a separate statusbar for DWM, which is my WM).

On the new Intel-based laptop, I can only manage to get one big screen, which is not what I want. After googling around, I can't seem to find any hints on how to accomplish what I want through xrandr - which is also what I used on the old laptop. I'm aware that I'm asking something very basic that I should be able to figure out by my self, but time is not on my side on this one...

How can I set up a temporary secondary monitor, which is a separate screen by itself with its own DWM statusbar that I can move applications to and from? Thanks!

Last edited by Unia (2013-10-05 12:29:30)


If you can't sit by a cozy fire with your code in hand enjoying its simplicity and clarity, it needs more work. --Carlos Torres

Offline

#2 2013-10-05 12:29:13

Unia
Member
From: Stockholm, Sweden
Registered: 2010-03-30
Posts: 2,486
Website

Re: [SOLVED] Setting up a secondary monitor

Solved by recompiling DWM with Xinerama support roll


If you can't sit by a cozy fire with your code in hand enjoying its simplicity and clarity, it needs more work. --Carlos Torres

Offline

Board footer

Powered by FluxBB