You are not logged in.

#1 2013-10-08 21:24:26

lorcap
Member
From: Italy
Registered: 2013-10-08
Posts: 4

Illegal instruction in libdrm.so.2

Hi everyone,

I'm trying to set up a little media server using an old motherboard VIA EPIA M10k which mounts an embedded VIA Eden ESP processor and a VIA Apollo CLE266 chipset. When I try to start X with 'startx', I get the error below (full 'Xorg.0.log' available).

Do you think this is because I'm running X on a VIA processor?
If I try to recompile 'libdrm', do believe I can get around it? Or should I contact the package maintainer?

Thanks.

[  1099.400] (II) OPENCHROME: Driver for VIA Chrome chipsets: CLE266, KM400/KN400,
        K8M800/K8N800, PM800/PM880/CN400, VM800/P4M800Pro/VN800/CN700,
        CX700/VX700, K8M890/K8N890, P4M890, P4M900/VN896/CN896, VX800/VX820,
        VX855/VX875, VX900
[  1099.401] (II) VESA: driver for VESA chipsets: vesa
[  1099.401] (II) modesetting: Driver for Modesetting Kernel Drivers: kms
[  1099.401] (II) FBDEV: driver for framebuffer: fbdev
[  1099.401] (--) using VT number 2

[  1099.415] (!!) VIA Technologies does not support this driver in any way.
[  1099.415] (!!) For support, please refer to http://www.openchrome.org/.
[  1099.415] (!!) (openchrome 0.3.3 release)
[  1099.415] (WW) Falling back to old probe method for vesa
[  1099.415] (WW) Falling back to old probe method for modesetting
[  1099.416] (EE) 
[  1099.416] (EE) Backtrace:
[  1099.416] (EE) 0: /usr/bin/X (xorg_backtrace+0x49) [0x81d7e89]
[  1099.417] (EE) 1: /usr/bin/X (0x8048000+0x193bf4) [0x81dbbf4]
[  1099.417] (EE) 2: linux-gate.so.1 (__kernel_rt_sigreturn+0x0) [0xb775240c]
[  1099.417] (EE) 3: /usr/lib/libdrm.so.2 (drmIoctl+0x3b) [0xb7676adb]
[  1099.417] (EE) 
[  1099.417] (EE) Illegal instruction at address 0xb7676adb
[  1099.417] (EE) 
Fatal server error:
[  1099.417] (EE) Caught signal 4 (Illegal instruction). Server aborting

Offline

#2 2013-10-09 12:14:41

lorcap
Member
From: Italy
Registered: 2013-10-08
Posts: 4

Re: Illegal instruction in libdrm.so.2

Because my sole purpose was to run mythtv-setup, I found a workaround.  By forwarding X11 protocol via ssh, I can lunch the setup without actually running X on the mythtv box.

Offline

Board footer

Powered by FluxBB