You are not logged in.
Pages: 1
Topic closed
Hello . . .
Today I upgraded Arch, and now VirtualBox is unable to start a saved machine. It was working just fine before the update.
When I try to start a saved machine VirturalBox Manager replies with:
Failed to open a session for the virtual machine.
Failed to load unit 'PATM' (VERR_SSM_FIELD_NOT_CONSECUTIVE).
Result Code:
NS_ERROR_FAILURE (0x80004005)
Component:
Console
Interface:
IConsole {8ab7c520-2442-4b66-8d74-4ff1e195d2b6}
After removing saved state and starting the machine again, it loads fine. If a save state is set, the manager fails to start, and gives the error. This feature was working just fine before the update.
- The BIOS is set to support virturalization.
- The kernel and drivers are current.
How can I cure this problem?
Offline
Offline
Where is the svn?
Offline
It should alreade be fixed in latest official arch package, maybe you haven't updated your system for a while?
Offline
Sorry to bump this thread, but I am facing this problem in several realeases on virtualbox.
I am on version 4.3.18..
In onlder realeases (can't remember the number) it was running fine.
Lenovo Thinkpad X230/12.5' Flexview IPS/Samsung 830 256Gb SSD/16GB DDR3/Intel HD4000/Intel 6205 Wifi
Offline
Skinne,
I think the original problem had been dealt with by a package update about a year ago. Your problem should not be related.
I am going to suggest that you please start a new thread as I am going to close this one. If you believe this thread to be relevant. then pleas provide a link back to this thread from the new thread.
Thanks.
Nothing is too wonderful to be true, if it be consistent with the laws of nature -- Michael Faraday
The shortest way to ruin a country is to give power to demagogues.— Dionysius of Halicarnassus
---
How to Ask Questions the Smart Way
Offline
Pages: 1
Topic closed