You are not logged in.
Hi!
I just installed Arch Linux on my desktop computer. After following the steps detailed in the beginner's guide, I proceeded to install the nvidia package, zsh, x11 and xmonad.
During the installation of xmonad, pacman seemed to stop after installing the first package with "haskell" in its name was completely installed. When I sent it to the background, top showed a process of "ghc-pkg" eating 100%CPU and about 6G RAM.
I waited for maybe 5 minutes for this process to complete, and since it failed to do so, killed it. This caused pacman to install ne next "haskell-.." package, freezing again after this one, again with one process of "ghc-pkg" at 100% load.
When I killed every process of either "ghc-pkg" and "haddock" that appeared in top, I got pacman to finish the installation, but the same problem prevents using it. Calling ghc or ghci causes this program to load out the CPU and consume increasing amounts of RAM, without getiing any output from them.
What could be my problem here?
Thanks much for reading ![]()
P.S.: I don't know if that's related, but "htop" always segfaults as soon as its started (before any output). I am pretty sure I have no hardware problem, though, since the parallel Windows 8 installation has been rock-solid forever.
Last edited by ngollon (2013-12-11 10:54:32)
Offline