You are not logged in.
Pages: 1
Hi there,
I attached an external monitor via displayport to my lenovo x230 (Intel HD4000).
If I set the resolution to be 1920x1080 (or lower) everything runs fine. If I switch to the monitors native resolution (1920x1200) the monitor turns off after about 1 minute. The monitor tries to turn on again for two to three times, but only for few seconds.
If I dual boot to windows the monitor is running fine.
Any idea what might be the cause and how to fix it?
Thanks a lot
Offline
Config xorg, driver installed .... pick up the crystal ball and your answer in my thinkpad t430u (hd4000) with intel-dri, run perfect at 2560x.. or just the monitor is failing because raisins resolution supporting, i don't no. luck
Offline
Pages: 1