Arch Linux

zAo

Member

Registered: 2012-11-01

Posts: 26

Intel NUC DN2820 boot problems

Hi,

After hours of searching I still cant tackle this problem I have with my new Intel NUC DN2820. I could only start the bootcd with acpi=off, but installed fine afterwards.

I use legacy boot with a GPT scheme. There is a ef02 partition of 2M at the beginning of the SSD.

When I boot, I see the kernel being loaded (decompressing) and the system hangs with a scrambled screen:

screenshot

No, it's not the picture that is strange

I tried to boot the bootcd and started an old BIOS MBR install from disk, which went just fine.

Any ideas on what the problem is?

********** modedit **********
replaced full screenshot with link
please read our forum etiquette
/Xyne
*****************************

Last edited by Xyne (2014-03-16 12:50:58)