Arch Linux

degmic71

Member

Registered: 2009-02-03

Posts: 122

Virtualbox VERR_SUPDRV_COMPONENT_NOT_FOUND

Hi,

I'm trying to enable my pci device in my win 7 VM. So far I have done the following:

kernel:

Linux archboxmtd 3.13.6-1-ARCH #1 SMP PREEMPT Fri Mar 7 22:47:48 CET 2014 x86_64 GNU/Linux

software:

local/virtualbox 4.3.8-2
    Powerful x86 virtualization for enterprise as well as home use
local/virtualbox-ext-vnc 4.3.8-2
    VirtualBox VNC extension pack
local/virtualbox-guest-iso 4.3.8-1
    The official VirtualBox Guest Additions ISO image
local/virtualbox-guest-modules 4.3.8-1
    Guest kernel modules for VirtualBox
local/virtualbox-host-modules 4.3.8-1
    Host kernel modules for VirtualBox

Modprobe:

modprobe vboxnetadp vboxdrv vboxpci vboxnetflt 

I attached my device with::

PCI entry: 01:00.0 VGA compatible controller: NVIDIA Corporation GF114 [GeForce GTX 560 Ti] (rev a1)

VBoxManage modifyvm "Windows 7 64" --pciattach 01:00.0

Virtualbox options:

Acceleration: VT-x/AMD-V
Acceleration: Nested Paging
Motherboard: Chipset is ICH9, extended feature Enable I/O APIC

Error I am receiving

Failed to open a session for the virtual machine Windows 7 64.
One of the kernel modules was not successfully loaded. Make sure that no kernel modules from an older version of VirtualBox exist. Then try to recompile and reload the kernel modules by executing '/etc/init.d/vboxdrv setup' as root (VERR_SUPDRV_COMPONENT_NOT_FOUND).


Result Code: 
NS_ERROR_FAILURE (0x80004005)
Component: 
Console
Interface: 
IConsole {8ab7c520-2442-4b66-8d74-4ff1e195d2b6}

Any help or debugging steps?

Last edited by degmic71 (2014-03-22 23:00:27)